DETERMINATION OF THE TEMPERATURE FIELD DISTRIBUTION IN THE WINDING RODS OF THE STATOR OF TURBOGENERATORS OF TYPE TVV FOR PURPOSES OF CONTROL AND DIAGNOSTICS

Authors

DOI:

https://doi.org/10.20535/1813-5420.3.2022.271987

Keywords:

turbogenerator; stator winding; temperature field; mathematical model; electric machine.

Abstract

Turbogenerators were and remain the most unreliable element at nuclear power plants in Ukraine. The most dangerous disturbances in the operation of turbogenerators of the TVV type is complete or partial blockage of the hollow conductors of the stator winding. The systems of operational control and technical diagnostics today, in a number of cases, cannot cope with the identification of these phenomena. The complex application of adequate mathematical models, indications of the standard thermal control system and new diagnostic features give the opportunity with sufficient accuracy for practical purposes to detect blockages in the hollow conductors of the stator windings of these turbogenerators. The aim of the work is to develop a program for calculating the three-dimensional temperature field in the rods of the stator winding of a turbogenerator of the TVV-1000-2U3 type, taking into account the temperature field of the stator core, to carry out a test calculation and to compare the experimental and to calculated data. The problem is solved with the help of the finite difference method using the integro-interpolation method.

References

O.V. Vyhovskyi, “The main problems of nuclear energy development in Ukraine and ways to solve them”, Safety issues of nuclear power plants and Chernobyl, no. 27, pp. 5–12, 2016.

O.H. Kensytskyi, H.M. Fedorenko, “Reliability of generating equipment and prospects for the development of nuclear energy in Ukraine”, Safety issues of nuclear power plants and Chernobyl, no. 26, pp. 69–74. 2016.

S.V. Zhuravljov, Yu.N. Samorodov “Typical defects of turbogenerators found in operation”, Reports of the technical seminar « Improving the organization of operation and increasing the reliability of turbogenerators », pp. 21–26, 2005.

V.S. Belov, A.H. Zolotykh, K.S. Lobanov, “Diagnostics of operating modes of turbogenerators and their cooling systems”, Electric stations, no. 12, pp. 61–65, 2007.

V.Y. Yohansen, N.D. Pynchuk, V.Y. Sharov, “Measures to increase the reliability of operation of two-pole turbogenerators with a capacity of 800 MW and 1000 MW installed at thermal and nuclear power plants”, Reports of the technical seminar « Improving the organization of operation and increasing the reliability of turbogenerators », pp. 40–46, 2005.

V.Y. Poliakov, “Diagnostics of the technical condition of water cooling channels and fastening of winding rods of powerful turbogenerators to extend their service life”, Electric stations, no. 10, pp. 34–39, 2001.

O.V. Vyhovskyi, “Diagnostic signs of blockage of empty conductors and an advanced strum in the elementary conductors of the stator winding”, Nuclear energy and the environment, no. 1(16), pp. 19–30, 2020.

O.V. Vyhovskyi, T.V. Krasnianskaia, “Simulation of stationary and transient thermal processes in the stator windings of powerful turbogenerators of the TVV type in a three-dimensional setting”, Wschodnioeuropejskie Czasopismo Naukowe (East European Scientific Journal), 53 part 3, pp. 12–23, 2020.

O.H. Kensytskyi, O.V. Vyhovskyi, “Estimation and analysis of additional losses in the stator winding rods of a powerful electric machine”, Hydropower of Ukraine, no. 2, pp. 18–21, 2010.

O.V. Vyhovskyi, “Determination of loss distribution and heating of stator core packages of TVV-1000 turbogenerator core of nuclear power plants”, The Proceedings of the Institute of Electrodynamics of the National Academy of Sciences of Ukraine, vol. 25, pp. 42–46, 2010.

Yu.N. Samorodov, “Diagnosis of the operational condition of the insulation of large generators”, Ph.D. dissertation, Dept., Moscow, 1990.

Published

2023-03-09

Issue

Section

TECHNOLOGIES AND EQUIPMENT IN ENERGY